• Systems are available with 2, 3, 4 or 5 sensors
  
• ALL sensors control height
  
• Outer sensors control lateral tilt if combine is equipped
  • Works with most combine and header combinations
  • Use OEM in-cab controls
  • Connect with no splicing required
  • Allow use of all other header functions (lights, reel, etc)
    
• Effective sensor design
  • Poly arm helps protect sensor from damage
  • Spring down pressure enhances signal accuracy
  • Three sensor choices to optimize performance
  • Ground contact near or in front of cutterbar
  • Sensing point moves forward at lower cutting heights

Kit Components
Every Headsight® kit includes everything you need for header height control.
*If combine is equipped with header height control.

• Standard Sensor
  • Most versatile
  • Cutterbar mount available for rigid headers
    

• Terrace Sensor
  • Mounts in front of cutterbar
  • Recommended for quickly changing or terraced ground
  • May lay over uncut crop
    

• Ridge Sensor
  • Dual sensing wands
  • Recommended for furrowed or ridged ground
  • Sensing wand
  • Long wands allow higher maximum cutting height (~15”)
  • Short wands in center for closer cutting in rolling/terraced ground

  Mounting Brackets (if required)

Header-to-Combine Wiring

• May adapt unmatched head and combine
  • Old to New
  • Red to Green
  • etc

• Interface Control Box (if required)
  • “Translates” sensor signals to format that combine can utilize
  • Allows use of new potentiometer sensors with older combines
  • Provides capability to use more sensors than OEM systems
  • Includes in-cab Infinite Height Control knob if needed

Pictures show representative components, actual components may vary)